Using the Tabs Without the App (Independent Mode)

The Tabs can be used without the Dharma Dr app in Independent Mode. This allows you to quickly run a session using built-in default settings, even if you don’t have your phone nearby.

Steps

1. Remove Tabs from the charging case
   The Tabs will automatically power on when removed from the case.
2. Enter Independent Mode
   Press the button on each Tab once.
3. Use the Tabs
   Hold one Tab in each hand and follow the instructions below to control them.
   1. Speed Tab: The ~ line Tab controls the speed. Slow, Medium, Fast, then off if pressed again.
   2. Intensity Tab: The volume bar Tab controls the intensity. Low and High
4. End the session
   Press the button on the ~ symbol tab until it stops.

Default Settings in Independent Mode

• Vibration: 2 Intensity settings, a low and high.
• Lights: On, alternating between left and right
• Audio: Off (not available without the app)
• Cycle speed: 3 speed settings, slow, medium, and fast.

Troubleshooting

• Tabs not turning on — Make sure they are charged. Place them in the case and charge for at least 30 minutes.
• No vibration — Confirm you pressed the button to enter Independent Mode. If still not working, reset by closing the case lid for 10–15 seconds, then remove the Tabs again.
• Lights not alternating — Restart by pressing the Tab buttons again, or place Tabs back in the case and re-remove.

Tips & Best Practices

• Independent Mode is useful for quick sessions but has limited customization.
• For full control of speed, intensity, and modes, connect through the Dharma Dr app.
• Always recharge Tabs after sessions to prepare them for next use.

Related Articles

• Using Lights-Only (Tactile Off) Mode
• Using Audio BLS
• Troubleshooting – Complete Guide